Malibu, CA · Owner-operated

Duct Repair & Sealing in Malibu, CA

Leaky, loose or crushed ducts waste heated and cooled air and pull in dust from attics and crawl spaces. We repair and seal them so air reaches the rooms it is meant for.

Call (310) 361-9813 Request an estimate

20+ years of experience
Phone answered 24/7
Before-and-after photos

Quick answer

Duct repair and sealing fixes disconnected, crushed, torn or leaking ductwork and the boots behind each vent. Crystal Air Duct Solutions reconnects and secures loose sections, replaces damaged runs, and seals joints and boots with mastic or foil tape so conditioned air stays in the system.

Duct Repair & Sealing

Duct Repair & Sealing done thoroughly, by the owner

Many duct problems are found during cleaning: a flex duct pulled off its boot, foil tape that has peeled away, or a crushed section in the attic. Each one lets air escape and lets dust in.

Common signs are rooms that never get as warm or cool as the rest, higher energy bills and dust that keeps returning. We show you photos of any damage and give repair options before doing any work.

Call (310) 361-9813 any time; the phone is answered 24/7, and appointments run every day from 6 AM to 8 PM.

Register boot with old foil tape, stains and a dusty damper — A boot with old tape and staining, a common spot for air leaks.

What's included

Inspection with photos of damaged sections
Loose or disconnected ducts reattached and secured
Crushed or torn runs replaced
Boots resealed to the drywall and duct
Joints sealed with mastic or foil tape
Airflow check at the registers after repair

Call (310) 361-9813

Why sealing matters near the coast

Leaky return ducts pull air from attics, crawl spaces and garages, which brings in dust, insulation fibers and, in coastal homes, humid salt air. Sealing the returns is one of the best ways to keep the system cleaner.

Sealing also helps rooms at the end of long duct runs get the airflow they need.

How it works

What to expect

Every job follows the same careful steps.

Inspect
We look inside the registers, returns and accessible duct runs and show you photos of what we find before quoting.
Protect
Floors, furniture and the area around each vent are covered before any equipment comes inside.
Connect the vacuum
A high-powered vacuum is connected to the system so loosened dust is pulled out, not pushed into your rooms.
Brush and clean
Rotary brushes and air whips work through each supply and return run, boot and register.
Fix what is needed
Loose connections, torn tape or damaged sections we find are pointed out, with repair options before any extra work.
Walk through the results
You see before-and-after photos, and we answer every question before we leave.